Skip to content
Ideal Electrical Solutions

Ideal Electrical Solutions · Prescott, ArizonaLicensed electrician in Prescott

Residential electrical work across the Quad Cities: panels, service upgrades, EV chargers, surge protection, generator hookups, lighting, outlets, and repairs. Panels and service upgrades are the jobs we do most and know best. Permit pulled and inspection passed, every job.

AZ ROC #365428, CR-11 ElectricalSince 2016Efficiency Arizona Qualified ContractorPermit pulled on every job

What we doEverything from the meter to the outlet

Our specialty100 to 200A

Panel Upgrades

We replace Federal Pacific, Zinsco, and overcrowded panels with new 100 to 200 amp equipment, permitted and inspected, with a labeled directory and photos for your insurer.

How a panel upgrade goes
Specialty200 to 400A

Service Upgrades

New meter socket, mast, service entrance conductors, and main disconnect, sized for 200 or 400 amps and scheduled around APS.

Details
SpecialtyLevel 2

EV Chargers

Level 2 charger circuits, 40 to 60 amps, NEMA 14-50 or hardwired, sized to what your panel can actually carry.

Details
SpecialtyType 2 SPD

Surge Protection

A Type 2 surge protective device mounted at the panel, sized for monsoon lightning and the small utility surges that wear electronics out.

Details
SpecialtyTransfer switch

Transfer Switches

Manual transfer switches, interlock kits, generator inlets, and automatic transfer switches for standby units, wired to code and inspected.

Details
SpecialtyWritten report

Safety Inspections

A licensed electrician's look at the panel, wiring, and devices, with a written report you can hand to a buyer, a seller, or an insurance underwriter.

Details
GeneralDiagnose first

Repair and Troubleshooting

Tripping breakers, dead circuits, warm outlets, flickering lights, and aluminum branch wiring, found at the source and fixed properly.

Details
GeneralFans to GFCI

Lighting, Fans and Outlets

Ceiling fans on boxes that can hold them, recessed lighting laid out for the room, GFCI and AFCI protection, and dedicated circuits for the appliances that keep tripping the kitchen.

Details
GeneralDedicated 240V

Hot Tub and Mini-Split Circuits

Dedicated 240 volt circuits for hot tubs and mini-split heat pumps, with the GFCI disconnect, the whip, and the conduit run done to code and inspected.

Details
Old crowded electrical panel with unlabeled breakers before replacement New 200 amp electrical panel with the door open and a labeled circuit directory Before After
Crowded · unlabeled · no roomNew load center · labeled · inspected

Our specialtyPanels and service upgrades are the work we know best

Nearly half of Prescott's homes went up between 1970 and 1999, and that is where Federal Pacific Stab-Lok and Zinsco panels live. Many Arizona carriers now decline or non-renew a policy once an inspection names one. Every home sale in that vintage produces an inspection report, and every report with an FPE or Zinsco note produces a phone call to us.

We have replaced panels since 2016, and it is still where most of our calls start. It sits inside a full electrical practice, though: the same truck handles the hot tub circuit, the ceiling fan, and the outlet that went dead.

  • Written quote from two photos. Text us the panel with the door open and the meter. Permit included in the price.
  • Permit and inspection on every job that needs one. City of Prescott, Prescott Valley, Chino Valley, Dewey-Humboldt, or Yavapai County.
  • Insurance letter and a filled-out directory before we drive away.
More on panel upgrades
Efficiency Arizona Qualified Contractor badge

Efficiency Arizona · Home Energy Rebates

A Qualified Contractor for the state's panel and wiring rebates

Income-eligible households replacing an electric appliance with a heat pump, heat pump water heater, or other qualified appliance can have the panel upgrade and wiring covered in part or in full. We are in the program's contractor network, and the rebate comes off the invoice.

How the rebate works

How a job goesFour steps, no surprises

  1. Step 1

    Text a photo

    The panel, the outlet, or the spot where the charger goes, plus your address. We reply with a written quote and whether a permit is involved.

  2. Step 2

    Permit handled

    When the job needs one, we file with your city or the county and schedule APS if the service is involved.

  3. Step 3

    The work

    Done to current code on the day we said, with the house put back the way we found it.

  4. Step 4

    Inspected and documented

    Inspector signs off where required. You get photos, labeled circuits, and any letter your insurer or buyer needs.

On the jobWork we are proud of

New 200 amp panel with the door open and a labeled circuit directory
200A upgrade · labeled
Eaton transfer switch components laid out before installation
Generator transfer switch
New meter main combination service entrance mounted on an exterior wall
New service entrance
Outlet and switch wiring in a bathroom remodel
Bathroom outlets · GFCI

Service areaThe Quad Cities, and the ranches between

Based in Prescott. Electrical work across the four towns, plus Williamson Valley and Paulden by appointment. Full service area.

Open in Google Maps

Questions we get on the phoneStraight answers

Is my Federal Pacific or Zinsco panel insurable in Arizona?

Often not. Many Arizona carriers decline a new policy, or will not renew, once an inspection names a Federal Pacific Stab-Lok or Zinsco panel. Replacing it with a modern load center, permitted and inspected, is what they ask for. We provide the photos and the letter they want.

Do you take smaller jobs, like a ceiling fan or a few outlets?

Yes. Panels and service upgrades fill most of the schedule, but lighting, fans, outlets, GFCI and AFCI protection, hot tub circuits, and troubleshooting are regular work for us. Text a photo of what you need and we quote it the same way.

Do I need a permit for electrical work in Prescott?

For most of it, yes. Panels, service upgrades, new circuits, EV chargers, and hot tubs all need one in every Quad Cities jurisdiction; swapping a fixture or an outlet usually does not. We pull the permit when the job needs it and meet the inspector. The City of Prescott issues same-day permits for panel replacements up to 200 amps.

Can I add an EV charger to a 100 amp panel?

Sometimes. We run a load calculation first. A 40 amp charger with load management often fits on a 100 amp service. A 48 or 60 amp charger on a house with electric heat or a hot tub usually means a 200 amp upgrade, and we will say so up front.

How does a generator connect to the house safely?

Through a transfer switch or a listed interlock kit, never a cord into a dryer outlet. That is a backfeed, and it can energize the APS lines a crew may be working on. We install manual switches, interlock kits, generator inlets, and automatic transfer switches, permitted and inspected.

Photo estimateSend a photo. Get a written number.

A photo of the panel, the outlet, or the spot where the charger goes is usually enough, and the meter outside helps. We reply with a written quote within one business day. No pressure, no invented urgency.

(928) 482-2230

Call or text

Request a photo estimate

A photo of the panel with the door open (cover on), or of whatever needs work, plus the meter outside. We reply with a written quote within one business day.

AZ ROC #365428, CR-11 Electrical · Bonded · Insured

Call Text photos Estimate